How to Change a Waterpump in a Jeep

This video shows how to change a water pump in a Jeep Wrangler straight 6cyl. This will work on any jeep from 1996-2005 with the 4.0 Inline 6. Can also be used for earlier jeeps as well. A bad waterpump will cause you to overheat and would make it difficult to continue driving. It is easy to replace the waterpump and watching this video should prove that to you. Any questions feel free to comment below.

Here is the water pump I used: amzn.to/43GqAWg

**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Thursday**

0:00 Symptoms of a bad water pump
1:01 Fan removal
3:12 Fan shroud removal
4:50 Loosen water pump pulley bolts
5:38 Belt removal
6:45 Water pump removal
12:40 Prep new water pump
14:06 Thermostat replacement
17:04 New water pump install
20:49 Belt and fan parts install

-As an Amazon Associate I earn from qualifying purchases.
-Website: ChrisFixed.com
-Facebook: facebook.com/chrisfix8
-Twitter: twitter.com/ChrisFixed
-Instagram: instagram.com/chrisfixit
-Subscribe Here: youtube.com/subscription_center?add_user=paintb…
-YouTube Channel: youtube.com/ChrisFix

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.