How to Clean and Refinish Valves

So I know I told you that I’ve been working on the cylinder head for the past week, and that’s because I have… Getting the most out of your cylinder head requires a lot of man hours, and a lot of patience. I’ve been using carbide bits for the past week and I’m finding little chunks of aluminum everywhere. I still have lots of work to do to it, but in the mean time, I figured I’d show you how I brought back my old valves back to life.

Just like the P&P job, this isn’t a difficult task, however it is quite repetitive and time consuming. To make your life easier and to save you time, I’ve included a list of the tools that I used in this video to get this job done, and it make life SUUUUPER easy.

Dewalt Max XR 20v Hammer Drill Combo Kit ▶︎ goo.gl/avFMmt
Valvetrain Organizing Tray ▶︎ goo.gl/4Bz6pT
3M Fine Scotch-brite Pads ▶︎ goo.gl/fpjyxH
3M 800 Grit Sandpaper ▶︎ goo.gl/1dxcYv
3M 1000 Grit Sandpaper ▶︎ goo.gl/hmNSDe
3M 1500 Grit Sandpaper ▶︎ goo.gl/QxtwM9
3M 3000 Grit Sandpaper ▶︎ goo.gl/BrhqCY
Mothers Metal Polish ▶︎ goo.gl/qKWodq
Shop Towels ▶︎ goo.gl/3Sb6dD

Camera Used for this Video ▶︎ goo.gl/C1mN2C
Camera Used for Alternate Shots ▶︎ goo.gl/TN4ZgG

Don't forget to give it a like 👍 and follow 👣
milanmastracci YouTube Channel youtube.com/user/milanmastracci/
milmast Instagram ▶︎ instagram.com/milmast/

If you have any questions, feel free to send me an email at [email protected]. Thanks for watching!! :)