How To Wire and Install a SubWoofer Into an Enclosure

I'm nearly ready to finally install this custom subwoofer into by car but there is one more step. I need to wire up the sub and bolt it down. Wiring is super simple if your using a single voice coil but can get a bit more complicated if your using more than one. I show and explain the differences between wiring in parallel and series and where to actually place the wires. I bolt it down and were ready to finally install this thing. Thanks for watching and have fun!

Disclaimer: Work on your subwoofer and enclosure at your own risk. You are solely responsible for your own actions. Always use proper safety equipment for the job.

speaker Impedance Calculator: speakerimpedance.co.uk/

Find this Subwoofer, Amplifier, and wiring kit here:
Rockford Fosgate P3D4-10 Punch Subwoofer: amzn.to/376PE7T (paid link)
Rockford Fosgate R500X1D Prime 1-Channel Class D Amplifier amzn.to/36Y76vj (paid link)
InstallGear 4 Gauge Complete Amp wiring Kit: amzn.to/31ulNVX (paid link)

you can find some of the tools and supplies similar to what I used here:
spade connector crimps (to connect to terminal cup): amzn.to/2KiH5OE (paid link)
My favorite crimpers: amzn.to/3bmaSBS (paid link)
My favorite wire strippers: amzn.to/2S5kfOT (paid link)
DEWALT Cordless Drill & Impact Driver Kit: amzn.to/2Kb8CkU (paid link)
Screwdriver Bit Set / Drill Bit Set: amzn.to/2ypGsQm (paid link)
Digital Multimeter: amzn.to/2KgG4Xh (paid link)
Router Circle cutting guide: amzn.to/2RMpF13 (paid link)
(I may get commissions for purchases made through links with "paid link" next to them)

music:
epidemicsound.com/referral/jht5h2/