How to Configure DHCP on a Cisco Router

Join the Discord Server!
discord.com/invite/QZ2B9GA3BH
---------------------
MY FULL CCNA COURSE
📹 CCNA - certbros.teachable.com/p/cisco-ccna?utm_source=…

FREE CCNA FLASHCARDS
🃏 CCNA Flashcards - certbros.com/ccna/flashcards

HOW TO PASS THE CCNA
📚 Get a great book - amzn.to/3f16QA5
📹 Take a video course - certbros.teachable.com/p/cisco-ccna?utm_source=…
✔ Use practice exams - certbros.com/ccna/Exsim

SOCIAL
🐦 Twitter - twitter.com/certbros
📸 Instagram - instagram.com/certbros
👔 LinkedIn - linkedin.com/company/certbros
💬 Discord - certbros.com/discord

Disclaimer: These are affiliate links. If you purchase using these links, I'll receive a small commission at no extra charge to you.
---------------------------------------------------------------------------------------------------------------

How To Configure DHCP On A Cisco Router

This Video will show you how to configure DHCP server on a Cisco Router.

It’s pretty simple to configure DCHP,, just a few lines are your all set!

Below is the commands to configure DHCP. I will explain what each one means further down.


service dhcp – Tells the router to turn on the DHCP service.

ip dhcp pool MAIN-POOL – Adds a DHCP pool named ‘MAIN-POOL’. The name can be changed to whatever you like.

network 192.168.1.0 255.255.255.0 – Tells the router to use the IP addresses within the 192.168.1.0 network which is any address between 192.168.1.1-192.168.1.254.

default-router 192.168.1.254 – This will be set as the default gateway on the DHCP clients

dns-server 192.168.1.1 – This will be set as the DNS server on the DHCP clients

ip dhcp excluded-address 192.168.1.254 – This stops DHCP from leasing out this address.


#ccna #cisco #networking