HDTutorial
EN
How To Machine and Square 6 Sides of a Block Using Only 2 Setups

Playback starts YouTube’s embedded player (privacy-enhanced mode).

How To Machine and Square 6 Sides of a Block Using Only 2 Setups

129,571 views October 25, 2016 9:42

Watch on YouTube
ChannelSuburbanTool Inc

Description from the creator

In this demonstration, I grab some roughly cut stock, takes it to our trusty Bridgeport, and machine all six sides of the stock using only two setups! I machined the stock into a 1-2-3 block, leaving approximately .03" of grind stock on all sides. The purpose of this demonstration was not to be precise right off the bat, but to quickly bring a piece of stock close to size by minimizing the amount of setups in the job; all while leaving some stock for grinding afterwards.

About this tutorial

SuburbanTool Inc published this 9:42 video tutorial on October 25, 2016. It has been watched 129,571 times on YouTube.

Category
Education
Duration
9:42
Published
October 25, 2016
Views
129,571
Likes
2,042

Tags

Share

Further reading

  • How to Machine Quilt Your First Quilt / Beginners Quilting Instructions generations-quilt-patterns.com

    Learn how to machine quilt this way so only half the quilt is ever under the arm of your sewing machine. It's easier to quilt with less bulk under the arm because it leaves more room for your hands. You have more contro…

  • Square Up Stock on a Vertical Mill : 7 Steps - Instructables instructables.com

    Use a machinists square to align the workpiece so that side 2 is perpendicular to the top of the stationary jaw of the vise. In the photo the square is pointing up, but you will get more surface contact if the square po…

  • 8 tips to square corners | WOOD Magazine woodmagazine.com

    Use drafting squares--which prove reliably accurate--to check your woodworking squares, as shown in photo. Checking for square Check your square's accuracy by comparing drawn lines made from opposing sides of the same r…

This tutorial in other languages