How to: Setup a Full Length Sizing Die

Hey Guys,

Here's another video from our "How To:" Series.

In this video I show you how to setup and use a Full Length Sizing (FLS)die. It's a fairly simple process there are just a few rules to remember.
1. Always lube your cases when Full Length Sizing. Only a small amount is needed to ensure the case does not get stuck.(trust me, you don't want that.)
2. Always read the instructions that came with your Press/Dies. Every die/press system is different, be sure you know how yours operates.
3. When your brass is hard to chamber, FLS it back to factory specs and it should be good to go again. I usually FLS once after every 5 neck sizes. Keeps my brass operating smoothly.

Thanks for watching! If you liked this video or the series, be sure to subscribe, Thumb up and keep an eye out for more on the way!

Cheers,

ASC Team.