HDTutorial
EN
HyperFormTutorial Creating Addendum for draw die

Playback starts YouTube’s embedded player (privacy-enhanced mode).

HyperFormTutorial Creating Addendum for draw die

1,174 views October 26, 2015 55:37

Watch on YouTube
ChannelSoumitra Vadnerkar

Description from the creator

This video is a tutorial of HyperForm Die Module which demonstrates how to create addendum surface for a draw die component right from its geometry preparation cleanup

About this tutorial

Soumitra Vadnerkar published this 55:37 video tutorial on October 26, 2015. It has been watched 1,174 times on YouTube.

Category
Education
Duration
55:37
Published
October 26, 2015
Views
1,174
Likes
11

Tags

Share

Further reading

  • A Direct Engineering Approach to Draw Die Binder Development ... sae.org

    A method of designing the binder developments of draw dies for sheet metal stampings that integrates the mathematics of formability, kinematics and friction into the design (i.e. synthesis) process is described. The met…

  • [PDF] Addendum Surface Modeling in Draw Die Design for ... semanticscholar.org

    In the process of draw die design for stamping automotive press panels, the addendum surfaces generated in metal forming simulation software cannot be used in downstream processes such as machining and making draw dies…

  • Die Science: Developing forming dies - Part III thefabricator.com

    Very deep part areas most likely will not need a draw bead or bar. The exact geometry of the addendum features most likely will be finalized during the forming simulation or die tryout (see Figure 4). Step 8: Simulate F…

This tutorial in other languages