HDTutorial
EN
How to mortise for pocket door hardware

Playback starts YouTube’s embedded player (privacy-enhanced mode).

How to mortise for pocket door hardware

52,648 views October 25, 2018 5:03

Watch on YouTube
ChannelJosh Briere

Description from the creator

Hardware Prep for Halliday Ballie HB 690 privacy lock body and edge pulls. This is the whole process from start to finish. Site made jig, done in place onsite.
#pocketdoors
#pocketdoorhardware
#router #doorhardware #doors

About this tutorial

Josh Briere published this 5:03 video tutorial on October 25, 2018. It has been watched 52,648 times on YouTube.

Duration
5:03
Published
October 25, 2018
Views
52,648
Likes
217

Tags

Share

Further reading

  • Mortise Style Pocket Door Hardware | Direct Door Hardware directdoorhardware.com

    Not all mortise boxes have a finger pull to help you slide the door out of the pocket to close the door, so you may want to purchase a finger pull and mount it above or below the mortise lock on the edge of the door. Ot…

  • Guide To Mortise Lock Installation Jigs | Locksmith Ledger locksmithledger.com

    To install a mortise lock into a wood or composite door requires a pocket drilled into the edge of the door with the centerline of the door prep at 39-3/16" above the finished floor. In the early days, the pocket was cu…

  • EMTEK KEYED POCKET DOOR MORTISE LOCK INSTALLATION MANUAL Pdf ... manualslib.com

    Page 1 Traditional Trim Installation Guide - Keyed Pocket Door Mortise Lock, Mount Outside Plate Install Lock Body Install Drive Bar Cylinder Use Cylinder Key to thread Drive Bar Cylinder clockwise on interior side of d…

This tutorial in other languages