HDTutorial
EN

Playback starts YouTube’s embedded player (privacy-enhanced mode).

How to Replace a 240 Volt Submersible Well Pump ~ Submersible Well Pump Removal & Installation

48,968 views October 25, 2019 15:41

Watch on YouTube
ChannelMark Jenkins

Description from the creator

Submersible Well Pumps: amzn.to/2OgUckA
Well Pump Wire: amzn.to/2TeRUmL
Wire Splice Kits: amzn.to/2FlzU6B
Torque Arrestor: amzn.to/2TRthC0

This video covers the process of replacing a deep well submersible well pump. I pulled a 1\2 hp Grundfos submersible well pump that had been in place for approximately 14 years. I installed a 3\4 hp Everbilt 2 wire submersible well pump. My son and I removed our existing submersible well pump, replaced the wire, and then installed the new submersible well pump. The process covered in this submersible well pump installation video will be the same or similar on most other deep well submersible pumps including Everbilt, Franklin, Grundfos, Utilitech, Red Lion and more. Along with covering how to replace a submersible well pump, the video also covers the process of how to install a submersible well pump torque arrestor, how to re-reseat a pitless adapter, how to use a waterproof well pump wire splice kit and more.

Submersible Well Pumps: amzn.to/2OgUckA
Well Pump Wire: amzn.to/2TeRUmL
Wire Splice Kits: amzn.to/2FlzU6B
Torque Arrestor: amzn.to/2TRthC0

Click here to subscribe bit.ly/ngdysub1 and don't forget to select the notification bell!

Mark Jenkins is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com

Disclaimer:
Due to factors beyond the control of Mark Jenkins, I cannot guarantee against improper use or unauthorized modifications of this information. Mark Jenkins assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Mark Jenkins recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Mark Jenkins, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Mark Jenkins.

About this tutorial

Mark Jenkins published this 15:41 video tutorial on October 25, 2019. It has been watched 48,968 times on YouTube.

Duration
15:41
Published
October 25, 2019
Views
48,968
Likes
694

Tags

Share

Further reading

  • How to Remove Submersible Well Pump | Hunker hunker.com

    Typically residing between 50 and 300 feet below the ground, the submersible pump is a cylinder attached to an electric motor. The motor is powered by a 220- or 240-V system that can give you a lethal shock and shouldn'…

  • How to Install and Wire a Well Pump - Well Pump Installation ... waterpumpsdirect.com

    Learning how to read well pump wiring diagrams is necessary to install a well pump properly. Deep submersible well pumps will be either 2-wire or 3-wire well pumps, and 3-wire well pumps will need a separately installed…

  • How to Replace a Submersible Well Pump (with Pictures) - wikiHow wikihow.com

    Just like removal, use 2 people at the well head, and another person to walk the flex pipe towards the well head. Insert the pump into the hole, and slowly start the decent. When the pump hits the water level, it may re…

This tutorial in other languages