How to Turn on First Time SENSOR 2000 FM Transmitter Quick Start-Low power FM Broadcast transmitter

👍For more information join to us on: tekobroadcast.com👍
👇👇 See more! 👇👇

👍You can contact us at: [email protected]👍
📞 Phone/Whatsapp: +39 351 8101472For more information visit tekobroadcast.com

⭐ SENSOR 600W 1200W 2000W. FM TRANSMITTER ⭐

✅. High Performances & Fully Customizable

TRANSMITTER QUICK START

On the SENSOR Series Transmitters the Output power must be set exclusively from the CELL 2000 Amplifier.
The output power of the SYNAPSE 30/50 Exciter must be set fixed at 10W and is not necessary to change, moreover, keeping it at 10W the maximum performances in terms of efficiency are achieved.
The sequence is: MAIN MENU-PROGRAM MODE-FW PROGRAM-FWD SET
The steps to set the power from the CELL 2000 are as follows:
• Start from the Main menu
• Go to the menù PROGRAM MODE and push Enter
• Go to the menù to set the power and push Enter
• Set the power with the keys Up and Down and push Enter
Press ESC to return to the Main menù

CONNECTIONS SENSOR 2000

ATTENTION PLEASE

CELL 2000 has a HIGH GAIN input so it needs only 800mW to work as power driving.

So it’s very important don’t put higher power in the input to avoid the risk of damage of the input amplifier.

For this reason is provided togheter with the transmitter an 10dB attenuator and it’s mandatory this is connected to between the ouput of the exciter and the input of the amplifier.

This is one of the biggest highligths of this kind of transmitter, in fact:
1) The exciter works always over a 50 Ohm load. 
2) The amplifier has always perfect 50 Ohms input amd, because it’s handle only 800 mW it’s capable to turn internally ON/OFF the input power in case of protection of the output amplifier.