HDTutorial
EN
How to use a powdered actuated tool or ram-set to attach a carpet strip

Playback starts YouTube’s embedded player (privacy-enhanced mode).

How to use a powdered actuated tool or ram-set to attach a carpet strip

17,208 views October 26, 2016 4:24

Watch on YouTube
ChannelJeffthemaintenanceman

Description from the creator

Today
I show you how to fasten a carpet tack strip using a powdered actuated tool or ram-set.This tool uses a 22 cal blank to drive a nail into concrete . I also find it a lot easier than banging away with a hammer.

About this tutorial

Jeffthemaintenanceman published this 4:24 video tutorial on October 26, 2016. It has been watched 17,208 times on YouTube.

Duration
4:24
Published
October 26, 2016
Views
17,208
Likes
52

Share

Further reading

  • Tapcons vs Ramset - Fine Homebuilding finehomebuilding.com

    Powder actuated fastners are not as prone to this unless you use very long ones - I would use relatively shot ones - say 2 and half inches but use them frequently. If they do their job, they will fuse with the concrete…

  • RAMSET® TRUE EMBEDMENT (TE) PINS - Powder Actuated Gas Nail ... ramset.com

    now collated for use in hilti® powder-actuated tools the industry’s most reliable .157” diameter pin now comes collated in 10-pin strips for use in hilti® dx351 and dx460 magazines. available in pin lengths from 1/2 to…

  • POWDER FASTENER & LOAD SELECTION CHART - Ramset ramset.com

    tool powder tool powder load fastener length (inches) gas tool powder tool powder load fastener length (inches) gas tool powder powder load 1 tf1200 t3mag r25 #3 grn .25cal strip 1 tf1200 t3mag r25 #3 grn .25cal strip 7…

This tutorial in other languages