The upper bushings i use 2 sockets and a vice. I have a press and press tools available. i just prefer this method. i have replaced 100's of control arm bushings this way over the years. And by doing it this way i can replace the lower bushings withou

Use a wrench or vice grips to hold one of the nuts tight. Then torque the other nut with a wrench. As the socket pushes the bushing, the opposite socket acts as a brace, pressing up against the housing essentially pressing the bushing into the housing. Af

I bought one of these Kits off of ebay and how do I get the front bearing installed, because I don't have a press to do it.? Go tho the hardware store of your choice and get a bolt that goes into the bushing, and is 2 1/2 times as long also get a nut