Playback starts YouTube’s embedded player (privacy-enhanced mode).
How To Bending?!
ChannelThis Old TonyDescription from the creator
Little follow up on the weld cart build where I did a lot of bending but didn't pay it much mind.
Sheet metal, specifically, but this goes for all bending in general (sheet, tube, pipe, bar, spoons etc etc etc)
Also, you should watch Stefan G do his thing: www.youtube.com/user/syyl
For the people asking, the ruler is called a "stop rule". Check this link out from Lee Valley (no relation): leevalley.com/us/wood/page.aspx?cat=1,43513&…
----
Music: Very Right - Jingle Punks
Sheet metal, specifically, but this goes for all bending in general (sheet, tube, pipe, bar, spoons etc etc etc)
Also, you should watch Stefan G do his thing: www.youtube.com/user/syyl
For the people asking, the ruler is called a "stop rule". Check this link out from Lee Valley (no relation): leevalley.com/us/wood/page.aspx?cat=1,43513&…
----
Music: Very Right - Jingle Punks
About this tutorial
This Old Tony published this 22:30 video tutorial on November 1, 2018. It has been watched 1,471,625 times on YouTube.
- Channel
- This Old Tony
- Category
- Science & Technology
- Duration
- 22:30
- Published
- November 1, 2018
- Views
- 1,471,625
- Likes
- 35,549