How to use a Robotic Pool Cleaner

All of us at our home office in Cedar Grove NJ want to thank you for purchasing the finest robotic cleaner on the market. Aquabot takes pride in every bot we build and it is our mission to take the chore out of your pool ownership.

We want to Thank You for Your Purchase - Foot note: Actual Aquabot Cleaners models do vary

Ok to get started simply unbox the cleaner and take a moment to review the manual

Please take a moment an review the manual

All Aquabot cleaners come ready to use, simply plug in the power supply into a GFCI approved outlet.

Power supply must be a minimum of 12 feet from the pool edge
Simply place your Aquabot in the water from the shallow end of the pool

Never place your bot in a pool that resembles a swamp – Aquabots ultra-fine filtration will clog very quickly
Never place your bot in pool water below x ° as the cold water will stiffen the cable, restricting movement
It’s best to hold the bot upside-down under water to rid the unit of air bubbles
Once your bot rests on the pool floor press the start button on the power supply
Activate the power supply – Foot note: Actual Power Supplies will vary

Once the cleaning cycle is finished, pull the bot gently to the pool edge and lift the bot out of the pool by the handle

Pull the cable gently to the pool edge
Pull the unit out of the pool by the handle
Do not lift the unit by the cable or the swivel
When the cleaning cycle is finished, simply rinse the cleaner off with fresh water, clean the filter bags or basket and store the bot and power supply in a dry shaded location
Give the bot a good rinse and hose out the filter baskets